====== Calibration Procedure ======

Find the ART case

{{:tracking_system:img_5818.jpg?300|}}
  
Remove the metal rods and L shaped alignment tool.

{{:tracking_system:img_5819.jpg?300|}}

Assemble the two metal rods to create a single T-shaped alignment wand.
 
{{:tracking_system:img_5823.jpg?300|}}
  
Position the L shaped alignment tool in the center of the CAVE floor.  The bottom left point on the L will be the position of the origin (0, 0, 0).

{{:tracking_system:img_5822.jpg?300|}}

From the rendernode, use the UltaVNC viewer to connect to the head node.  We want to see Dtrack2 from within the CAVE to help with calbiration.

{{:tracking_system:screenshot_2019-04-02_14.02.50.png?300|}}

If Dtrack2 is currently measuring, then use the menu to stop measurement.

From Dtrack2's menu select: **Calibration > Room**

{{:tracking_system:screenshot_2019-04-02_14.11.36.png?300|}}

The settings that you want is 410mm wand length, and the coordinate system should say "Power wall".
 
{{:tracking_system:screenshot_2019-04-02_14.13.33.png?300|}}

Then click the button labeled **Calibrate**.

Here is a video demonstration of how to wave the calibration wand within the CAVE.

{{ :tracking_system:img_5802.mp4 |}}