====== Cave Projectors ======

Model of Projector: Titan SX+ 330 3D-L

{{:cave_hardware_config:unadjustednonraw_thumb_dc.jpg?300|}}

[[http://www.projectorcentral.com/pdf/projector_spec_7352.pdf|Projector Spec Sheet]]

===== Projector Control Networks =====

On the side wall of the CAVE, there is a port for control devices labeled:
  * PROJ CTL
  * CTL NET

PROJ CTL is a mini-jack type connector and that is a hard-wired connection for a remote control.  It is not a fancy ethernet network, it is just the infra-red commands sent over serial cable.  The cables are connected in a daisy-chained manner on the projectors.  Each projector has a mini-jack "wired remote" input, and an "output" jack.

{{:cave_hardware_config:img_4853.jpg?300|}}
{{:cave_hardware_config:img_4854.jpg?300|}}

CTL NET is a RJ-45 connector that connects to a private control network that is connected to a Cisco switch in the basement.

Devices known to be on the Control Network:
  * Projectors
  * Crestron Control Device (mounted on the rack) 
  * Crestron's Touch Interface (on the desk in the CAVE)
  * Denon Audio Receiver
  * ART Cameras and Computers

CTL NET is on a subnet that is addressed: 192.168.5.*

Known IP Addresses:
^ Device Name                  ^IP Address ^Note ^ 
| Head Node                   | 192.168.5.160 |             |
| Render Node                 | 192.168.5.161 |             |
| Crestron Controller Device  | 192.168.5.10  |             |
| ART Controller Computer (Master)     | 192.168.5.162 | For DTrack2 Software|
| ART Controller Computer (Slave1)     | 192.168.5.163 | For DTrack2 Software|
| ART Controller Computer (Slave2)     | 192.168.5.164 | For DTrack2 Software|
| Left Wall                   | 192.168.5.30  | PROJECTOR 1 | 
| Left Center                 | 192.168.5.31  | PROJECTOR 2 |
| Right Center                | 192.168.5.32  | PROJECTOR 3 |
| Right Wall                  | 192.168.5.33  | PROJECTOR 4 |
| Left Ceiling                | 192.168.5.34  | PROJECTOR 5 |
| Right Ceiling               | 192.168.5.35  | PROJECTOR 6 |
| Left Floor                  | 192.168.5.36  | PROJECTOR 7 |
| Right Floor                 | 192.168.5.37  | PROJECTOR 8 |

There is no DHCP server on the control network, so all IP addresses have been manually
assigned.  If you connect a laptop, safe IP (unused) addresses to use are (subnet mask 255.255.0.0):

  * 192.168.5.8
  * 192.168.5.9